[6/19] The 3rd WPI-AIMR Joint Seminar in FY2015
The 3rd WPI-AIMR Joint Seminar in FY2015
Reactions and cell stack of lithium–air rechargeable batteries
Dr. Yoshimi Kubo
(National Institute for Materials Science)
Jun 19 (Fri.), 2015 16:00-17:00
Seminar Room, 2nd floor, WPI-AIMR Main Bldg.
Nonaqueous lithium–air (O2) rechargeable batteries have attracted much attention because of its huge theoretical energy density, which exceeds 1000 Wh/kg. Ether-based electrolytes have been proved to be rather stable for the oxygen reduction reaction at the cathode of lithium–air batteries, showing substantially improved cyclability without apparent side reactions. However, to realize such high energy density in practical applications, multiple lithium–air cells must be densely stacked, similar to the configuration of conventional lithium-ion batteries. This stacking requires a novel design of the cell stack in which air can be supplied to the cathode. We have recently developed an “air-breathing” passive stack of nonaqueous lithium–air batteries, where air is breathed in and out through porous current collectors sandwiched between cathodes. In this seminar, I will discuss the details of cathode reactions and present the results of cell stacking.
|Figure 1. (a)(b) Schematics of the air-breathing ten-cell stack of the lithium–air battery. (c) The photo during measurement.||Figure 2. (a) Cycling performance of the ten-cell stack. (b) A parallel result for a coin cell measured at the same current density and for the same discharge capacity.|
- Y. Okamoto and Y. Kubo, J. Phys. Chem. C 117, 15940-15946 (2013).
- Y. Kubo and K. Ito, ECS Trans. 62, 129-135 (2014).
General Affairs Section, AIMR Administrative Office